The new, modern, simple design...
Miniplane Shop Infos
Transportation cap to prevent your gas from going out by the event.
A tension spring for exhaust elements.Used to connect the different parts of the exhaust system mounted on the engine Top80
Cylinder head gasket engine paramotor Top80
Spring of the throttle for Walbro engine Top80.
Base gasket paramotor engine Miniplane Top 80Available in several thicknesses: 0.2mm 0.3mm 0.4mm 0.5mm 0.6mm
Nut + washer fixing flywheel
4 Motor mount screws.
Cable clamp for gas control
Plastic protection for the ignition stop button
Ring, spacer calibration that prevents the spark plug from touch the plunger
The valve box gasket is located between the valve box and the motor housing.
The carburetor gasket goes between the carburetor and valve box
Three springs for the fingers of a hand launcher Top80 engine.
Screws and washers kit to tighten the Top80 engine coil
Fixings engine hood paramotor Miniplane Top80
Throttle cable 1 mm stainless steel gas control Miniplane
Three short spacers to fix the ventilation turbine.
M4 screws to attach the launcher on the engine Miniplane Top 80
Rubber spacer for propeller fastening to Top80 engine
Velcro strap for securing the throttle in the pilot’s hand.
M5 screw + ring for fixing the propeller hub
Plastic gasoline filter, exterior in plastic, interior in cardboard.
Ergonomic handle to start your engine paramotor Miniplane Top80
A silent block exhaust 30x30 High Temperature. It connects the engine block to the exhaust.1 silent engine block 30 x 30 mm
Screw and bolt fixing silent exhaust block.
Ring For centering the oil reducer on the engine block
Rope marine type engine starter rotproof for Top 80
Oil for motor reducers TOP 80.
Kit of two springs for engine clutch Top 80
Steel plate starter cams and springs support for top80.
Molded spark plug cap screw on the cable coil output paramotor Miniplane Top80
Gasket between exhaust and engine cylinder Top 80. Reduces unburned fuel leaks.
The kit is composed of two springs and two nuts for engine exhaust top 80
Drain plug and gasket for gear engine Miniplane Top80
Wooden Seatplate for paramotor Miniplane std harness
Screw cap on top of the gear in oil bath. It incorporates a valve to prevent overpressure in the gearbox.
Bearing needles piston pin for motor Top80
Silent blocks Kit to secure the Top 80 engine on the Miniplane chassis.2 engine silent blocks 25 x 25 mm
Silent blocks Kit to secure the Top 80 engine on the Miniplane chassis.2 engine silent blocks 30 x 30 mm
Three manual motor starter pawls for Top80
Set of three screws securing the ventilation turbine on the Top80 engine
Plastic cap for fuel tank 12 liters on Miniplane Top80 paramotor
Pulley returns angle for the passage of accelerator cord to fix on the harness of paraglider and paramotor
Keychain with mirror system unwinder callback. Pull the mirror, connected by a wire hook and place the front of the tank to control the fuel level. Then release the mirror which come back on the hook remained attached to the harness.
Spring shaped tab which facilitates the initiation of a carburetor mounted on the PPG walbro Miniplane Top80
Starter spring for Miniplane Top 80 engine
Aluminum mounting flange propeller engine Top 80
Stainless steel shackle lyre to connect harness to the mobile bars.
4 quick clips pack for the paramotor frame Miniplane
Top connection Miniplane bows. Cage 115 or 125.